#25 - Square braceletThis tutorial shows how to tie the square bracelet #25. If you want a printer-friendly version in PDF, click here.
To make this bracelet, you will need yarn or threads in different colours. In this example I've used 8 threads. The length should be about 75 cm when you start to tie. Above you see a solution for starting.
Start with the outer threads and make knots towards the middle as the picture shows.
If you've done it right and tightened the knots, it will look about like this.
Continue to make knots towards the middle, using the same threads. When they meet, make either a left- or a right-hand knot.
Take the outer threads and make two knots towards the middle on both sides.
Take the outer threads again and make on both sides one knot towards the middle.
When you're done, it'll look about like this. In the next step you're going to use the threads in the middle and make outward knots.
As said, take the inner threads and do as the picture shows.
 
When you're done, it'll look like this. Now, take thread marked 1 in the picture, and make three knots to the right. After that, you can take thread 2 and do the same thing. And after that, with thread 3.
Now you can start at step 1 again, and repeat until the bracelet is long enough.Comments
| Likes |
|
brieee12, Huntress, superc, dap_hockey, Reesa and 2 others likes this.
Unlike |
|
|
|
this helped me so much! when i was a beginner and was new to the site, i had no idea how to make cool bracelets. only knew like the chevron and candy stripe. |
|
|
|
Cool! Is this a diamond pattern? |
|
|
|
right how do you do that
|
|
|
|
|
how do you???? |
|
|
|
Stefan, how do you generate those pictures, or make them. |
|
|
|
|
Fan page
